|
|
 |
|
• A bolt-in kit that allows you to eliminate the rear torsion bars in order
to change to coil-over suspension. • Comes with high quality chromoly Heim-ends with Kevlar liners. • Has machined load boss so wheel load is transferred to torsion housing. On stock torsion housings, it is necessary for the plate that replaces the spring blade to have an "offset" in order to line up properly with the trailing arm. Without it, the plates are mis-alingned adding UNDUE STRESS on all the welds on the trailing arm mounting plate, causing premature cracking of the trailing arms at these welds. "BEWARE OF CHEAP IMITATIONS THAT DO NOT HAVE THIS FEATURE! Available in the following: • Stock VW Type I IRS Torsion Housing - $220.00 • Aftermarket IRS Torsion Housing with 2" I.D. - $220.00 • Aftermarket IRS Torsion Housing with 2 1/4" I.D. - $240.00 All Prices are for complete sets including Heim Ends. MANUFACTURER DIRECT PRICES |
INTRODUCTION |